Scan Tool Testing and Procedures

DOOR LOCK: POWER DOOR LOCK CONTROL SYSTEM: DATA LIST / ACTIVE TEST

1. READ DATA LIST

HINT
Using a Techstream to read the Data List allows the values or states of switches, sensor, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the tester ON.

(d) Enter the following menus: Select: Body Electrical / Main Body or Back Door / Data List.

(e) According to the display on tester, read the "Data List".

Main Body:





Back Door:





2. PERFORM ACTIVE TEST

HINT
Using a Techstream to perform Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

(a) Connect a Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the tester ON.

(d) Enter the following menus: Select: Electrical Body / Main Body or Back Door / Active Test.

(e) According to the display on tester, perform the "Active Test".

Main Body:





Back Door: