Back Door Lock

2011 Toyota FJ Cruiser 2WD V6-4.0L (1GR-FE)SECTION Back Door Lock




DOOR LOCK: BACK DOOR LOCK: INSPECTION

1. INSPECT BACK DOOR LOCK

(a) Check the operation of the back door lock actuator.





(1) Apply battery voltage to the back door lock actuator and check the operation of the back door lock motor.

Standard:





If the result is not as specified, replace the back door lock.

(b) Check the resistance of the door lock and unlock switch.

(1) Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

Standard Resistance:





If the result is not as specified, replace the back door lock.

2. INSPECT BACK DOOR LOCK CYLINDER





(a) Check the resistance.

(1) Using an ohmmeter, measure the resistance between the terminals when the cylinder is operated with a key.

Standard Resistance:





If the result is not as specified, replace the back door lock cylinder.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.