Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2010TACOMA BASE, 4D PICKUP, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROL (SFI) SYSTEM (1GR-FE) (DIAGNOSTIC CODES (P0451-P2A00) & CIRCUIT TESTS)
2010 Toyota Tacoma Base, 4D Pickup, Standard
Engine Control (SFI) System (1GR-FE) (Diagnostic Codes (P0451-P2A00) & Circuit Tests)
2010 Toyota Tacoma Base, 4D Pickup, StandardSECTION Engine Control (SFI) System (1GR-FE) (Diagnostic Codes (P0451-P2A00) & Circuit Tests)
- SFI System
- DTC P0451: Evaporative Emission Control System Pressure Sensor Range / Performance; DTC P0452: Evaporative Emission Control System Pressure Sensor / Switch Low Input; DTC P0453: Evaporative Emission Control System Pressure Sensor / Switch High Input
- DTC P0455: Evaporative Emission Control System Leak Detected (Gross Leak); DTC P0456: Evaporative Emission Control System Leak Detected (Very Small Leak)
- DTC P0500: Vehicle Speed Sensor "A"
- DTC P0504: Brake Switch "A" / "B" Correlation
- DTC P0505: Idle Control System Malfunction
- DTC P050A: Cold Start Idle Air Control System Performance
- DTC P050B: Cold Start Ignition Timing Performance
- DTC P0560: System Voltage
- DTC P0604: Random Access Memory (RAM)
- DTC P0606: ECM / PCM Processor
- DTC P0607: Control Module Performance
- DTC P060A: Internal Control Module Monitoring Processor Performance
- DTC P060B: Internal Control Module A/D Processing Performance
- DTC P060D: Internal Control Module Accelerator Pedal Position Performance
- DTC P060E: Internal Control Module Throttle Position Performance
- DTC P0617: Starter Relay Circuit High
- DTC P062F: Internal Control Module EEPROM Error
- DTC P0630: VIN not Programmed or Mismatch - ECM / PCM
- DTC P0657: Actuator Supply Voltage Circuit / Open
- DTC P0724: Brake Switch "B" Circuit High
- DTC P1500: AC Inverter Malfunction
- DTC P1607: Cruise Control Input Processor
- DTC P2102: Throttle Actuator Control Motor Circuit Low; DTC P2103: Throttle Actuator Control Motor Circuit High
- DTC P2111: Throttle Actuator Control System - Stuck Open; DTC P2112: Throttle Actuator Control System - Stuck Closed
- DTC P2118: Throttle Actuator Control Motor Current Range / Performance
- DTC P2119: Throttle Actuator Control Throttle Body Range / Performance
- DTC P2120: Throttle / Pedal Position Sensor / Switch "D" Circuit; DTC P2122: Throttle / Pedal Position Sensor / Switch "D" Circuit Low Input; DTC P2123: Throttle / Pedal Position Sensor / Switch "D" Circuit High Input; DTC P2125: Throttle / Pedal Position Sensor / Switch "E" Circuit; DTC P2127: Throttle / Pedal Position Sensor / Switch "E" Circuit Low Input; DTC P2128: Throttle / Pedal Position Sensor / Switch "E" Circuit High Input; DTC P2138: Throttle / Pedal Position Sensor / Switch "D" / "E" Voltage Correlation
- DTC P2121: Throttle / Pedal Position Sensor / Switch "D" Circuit Range / Performance
- DTC P2195: Oxygen (A/F) Sensor Signal Stuck Lean (Bank 1 Sensor 1); DTC P2196: Oxygen (A/F) Sensor Signal Stuck Rich (Bank 1 Sensor 1); DTC P2197: Oxygen (A/F) Sensor Signal Stuck Lean (Bank 2 Sensor 1); DTC P2198: Oxygen (A/F) Sensor Signal Stuck Rich (Bank 2 Sensor 1)
- DTC P2237: Oxygen (A/F) Sensor Pumping Current Circuit / Open (Bank 1 Sensor 1); DTC P2238: Oxygen (A/F) Sensor Pumping Current Circuit Low (Bank 1 Sensor 1); DTC P2239: Oxygen (A/F) Sensor Pumping Current Circuit High (Bank 1 Sensor 1); DTC P2240: Oxygen (A/F) Sensor Pumping Current Circuit / Open (Bank 2 Sensor 1); DTC P2241: Oxygen (A/F) Sensor Pumping Current Circuit Low (Bank 2 Sensor 1); DTC P2242: Oxygen (A/F) Sensor Pumping Current Circuit High (Bank 2 Sensor 1); DTC P2252: Oxygen (A/F) Sensor Reference Ground Circuit Low (Bank 1 Sensor 1); DTC P2253: Oxygen (A/F) Sensor Reference Ground Circuit High (Bank 1 Sensor 1); DTC P2255: Oxygen (A/F) Sensor Reference Ground Circuit Low (Bank 2 Sensor 1); DTC P2256: Oxygen (A/F) Sensor Reference Ground Circuit High (Bank 2 Sensor 1)
- DTC P2420: Evaporative Emission System Switching Valve Control Circuit High
- DTC P2610: ECM / PCM Internal Engine Off Timer Performance
- DTC P2A00: A/F Sensor Circuit Slow Response (Bank 1 Sensor 1); DTC P2A03: A/F Sensor Circuit Slow Response (Bank 2 Sensor 1)
- EVAP System
- ECM Power Source Circuit
- VC Output Circuit
- Fuel Pump Control Circuit
- Fuel Injector Circuit
- ACIS Control Circuit
- MIL Circuit
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.