SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2010TACOMA BASE, 2D PICKUP, RWD, STANDARDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESCAN COMMUNICATION SYSTEM (DIAGNOSTICS & CIRCUIT TESTS)CAN COMMUNICATION SYSTEMCIRCUIT TESTSYAW RATE SENSOR COMMUNICATION STOP MODEDESCRIPTION
2010 Toyota Tacoma Base, 2D Pickup, RWD, Standard

Yaw Rate Sensor Communication Stop Mode: Description

2010 Toyota Tacoma Base, 2D Pickup, RWD, StandardSECTION Description
Detection Item Symptom Trouble Area
Yaw Rate Sensor Communication Stop Mode
  • Yaw Rate / Deceleration Sensor is not displayed on the "CAN Bus Check" screen of the Techstream.
  • "CHECK" screen of the Techstream. DTCs are output from each ECU in yaw rate and deceleration sensor communication stop mode as shown in the "DTC COMBINATION TABLE". Refer to PROBLEM SYMPTOMS TABLE .
  • Power source or inside the yaw rate and deceleration sensor
  • Yaw rate and deceleration sensor sub bus line or connector
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.