Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2010MATRIX FWD L4-2.4L (2AZ-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCAMSHAFT POSITION SENSORSERVICE AND REPAIRREMOVAL
2010 Toyota Matrix FWD L4-2.4L (2AZ-FE)
Removal
2010 Toyota Matrix FWD L4-2.4L (2AZ-FE)SECTION Removal
2AZ-FE ENGINE CONTROL: CAMSHAFT POSITION SENSOR: REMOVAL
1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Removal
2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE Removal
3. REMOVE CAMSHAFT POSITION SENSOR
(a) Disconnect the camshaft position sensor connector.
(b) Remove the bolt and the camshaft position sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.