Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA20104 RUNNER 2WD L4-2.7L (2TR-FE)REPAIR AND DIAGNOSISLIGHTING AND HORNSHEADLAMPSERVICE AND REPAIRREMOVAL AND REPLACEMENTREMOVAL
2010 Toyota 4 Runner 2WD L4-2.7L (2TR-FE)
Removal
2010 Toyota 4 Runner 2WD L4-2.7L (2TR-FE)SECTION Removal
LIGHTING (EXT): HEADLIGHT ASSEMBLY: REMOVAL
HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.
1. REMOVE FRONT BUMPER COVER
(a) Remove the front bumper cover Removal.
2. REMOVE FRONT BUMPER BAR REINFORCEMENT LH Removal
3. REMOVE HEADLIGHT ASSEMBLY LH
(a) Remove the 2 screws and bolt.
(b) Detach the clamp.
(c) Disconnect the connectors and remove the headlight.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.