Installation

2010 Toyota 4 Runner 2WD L4-2.7L (2TR-FE)SECTION Installation




DOOR LOCK: WIRELESS DOOR LOCK BUZZER: INSTALLATION

1. INSTALL WIRELESS DOOR LOCK BUZZER

(a) Connect the connector.





(b) Attach the clamp to install the wireless door lock buzzer.

2. INSTALL FRONT FENDER LINER LH (for X-Runner)

(a) Install 8 new grommets.





(b) Install the 4 screws.

(c) Install the pin hold clip.





3. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH (for X-Runner) Installation

4. INSTALL ROCKER PANEL MOULDING LH (for X-Runner)

5. INSTALL FRONT FENDER MUDGUARD LH (for X-Runner) Installation

6. INSTALL FRONT FENDER LINER LH (for Standard)

(a) Install 8 new grommets.





(b) Install the 2 screws.

(c) Install the pin hold clip.





7. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH (for Standard) Installation

8. INSTALL FRONT FENDER MUDGUARD LH (for Standard) Installation

9. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.