Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2009YARIS S, 4D HATCHBACKREPAIR AND DIAGNOSISENGINE MECHANICALAUXILIARY EMISSION CONTROL SYSTEMSPURGE VALVEINSTALLATION

2009 Toyota Yaris S, 4D Hatchback

Purge Valve: Installation

2009 Toyota Yaris S, 4D HatchbackSECTION Installation

INSTALL PURGE VSV
1. Install the purge VSV.
2. Engage the clip and connect the purge VSV connector.
  
  Fig 1: Locating Purge VSV Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FUEL VAPOR FEED HOSE NO. 2
1. Connect fuel vapor feed hose No. 2.
  
  Fig 2: Locating Fuel Vapor Feed Hose No. 2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FUEL VAPOR FEED HOSE NO. 1
1. Connect fuel vapor feed hose No. 1.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

Fig 3: Locating Fuel Vapor Feed Hose No. 1
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.