Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2009YARIS S, 4D HATCHBACKREPAIR AND DIAGNOSISENGINE MECHANICALAUXILIARY EMISSION CONTROL SYSTEMSCANISTERINSTALLATION

2009 Toyota Yaris S, 4D Hatchback

Auxiliary Emission Control Systems: Canister: Installation

2009 Toyota Yaris S, 4D HatchbackSECTION Installation

INSTALL CANISTER
1. Install the canister with the 3 bolts.
  Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf)
  
  Fig 1: Locating Canister Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the vent line hose to the canister.
3. Connect the air inlet line hose to the leak detection pump.
4. Connect the purge line hose.
  
  Fig 2: Locating Vent Line Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the connector.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

Fig 3: Locating Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.