Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2009YARIS S, 4D HATCHBACKREPAIR AND DIAGNOSISELECTRICALGAUGESMETERCOMBINATION METER (FOR HATCHBACK)INSTALLATION

2009 Toyota Yaris S, 4D Hatchback

COMBINATION METER (for Hatchback): Installation

2009 Toyota Yaris S, 4D HatchbackSECTION Installation

INSTALL COMBINATION METER ASSEMBLY
1. Install the combination meter assembly with the 2 screws.
2. Connect the 2 connectors.
INSTALL INSTRUMENT CLUSTER FINISH NO.1 PANEL
1. Fit the 3 A claws of the instrument cluster finish panel into the upper instrument cluster finish panel center.
  
  Fig 2: Identifying Instrument Cluster Finish Panel Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Engage the 4 claws and 5 clips and install the instrument cluster finish panel.
  
  Fig 3: Identifying Instrument Cluster Finish Panel Claws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL FINISH PANEL END RH
1. Connect the connector.
2. Engage the 5 claws and 3 clips and install the instrument panel finish panel end RH.
  
  Fig 4: Identifying Instrument Panel Finish Panel End RH Claws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL FINISH PANEL END LH
1. Connect the connector.
2. Engage the 5 claws and 3 clips and install the instrument panel finish panel end LH.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.