SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009YARIS S, 4D HATCHBACKREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLBRAKE CONTROLFRONT SPEED SENSORREMOVAL
2009 Toyota Yaris S, 4D Hatchback

Front Speed Sensor: Removal

2009 Toyota Yaris S, 4D HatchbackSECTION Removal
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE FRONT WHEEL 
  3. REMOVE FRONT FENDER LINER 
    1. Remove the 3 screws, 6 clips and 4 grommets and remove the front fender liner.
  4. REMOVE FRONT SPEED SENSOR 
    Fig 1: Locating Front Fender Liner With Screws, Clips And Grommets
    G04832244Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the speed sensor clip from the body.
    2. Disconnect the speed sensor connector.
    3. Remove the 3 clips.
    4. Remove the bolt and separate the clamp from the body.
    5. Remove the bolt and separate the clamp from the shock absorber.
    6. Remove the bolt and remove the speed sensor from the steering knuckle.
      NOTE:
      • Keep the speed sensor tip and installation portion free of foreign matter.
      • Remove the speed sensor without turning it from its original installation angle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.