Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2009YARIS S, 4D HATCHBACKREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMHEADLIGHT DIMMER SWITCHINSTALLATION

2009 Toyota Yaris S, 4D Hatchback

Headlight Dimmer Switch: Installation

2009 Toyota Yaris S, 4D HatchbackSECTION Installation

INSTALL HEADLIGHT DIMMER SWITCH
1. Engage the 2 claws and install the headlight dimmer switch, as shown in the illustration.
  
  Fig 1: Locating Headlight Dimmer Switch Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the headlight dimmer switch with the clamp.
3. Connect the connector.
  
  Fig 2: Locating Headlight Dimmer Switch Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL WIPER SWITCH
1. Engage the claw and install the windshield wiper switch.
2. Connect the 2 connectors.
INSTALL SPIRAL CABLE (See INSTALLATION )
INSTALL STEERING COLUMN COVER (for Hatchback) (See INSTALLATION )
INSTALL STEERING COLUMN COVER (for Sedan) (See INSTALLATION )
ADJUST SPIRAL CABLE (See INSTALLATION )

Fig 3: Locating Windshield Wiper Switch Claw
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING WHEEL ASSEMBLY (for Hatchback) (See INSTALLATION )
INSTALL STEERING WHEEL ASSEMBLY (for Sedan) (See INSTALLATION )
INSTALL STEERING PAD (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
INSPECT SRS WARNING LIGHT (See INSTALLATION )

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.