Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2009YARIS BASE, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE CONTROLBRAKE ACTUATORINSTALLATION

2009 Toyota Yaris Base, 4D Sedan, Automatic

Brake Actuator: Installation

2009 Toyota Yaris Base, 4D Sedan, AutomaticSECTION Installation

INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY (for Sedan)
1. Install the actuator bracket with the 2 nuts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  NOTE:
  - Do not remove the hole plug before connecting the brake tube. New actuators are filled with brake fluid.
  - Do not carry with the connector part of an actuator.
    
    Fig 1: Locating Nuts And Brake Actuator Bracket Assembly
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY (for Hatchback)
1. Install the actuator bracket with the 3 bolts in the sequence shown in the illustration.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  NOTE:
  - Do not remove the hole plug before connecting the brake tube. New actuators are filled with brake fluid.
  - Do not carry with the connector part of an actuator.
    
    Fig 2: Locating Bolts And Brake Actuator Bracket Assembly
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BRAKE ACTUATOR (for Sedan)
1. Install the brake actuator with bracket with the 3 bolts in the sequence shown in the illustration.
  Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf)
  
  NOTE: Do not damage the brake tubes or wire harness.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.