Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009YARIS BASE, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSTHEFT DETERRENTTHEFT DETERRENT SYSTEMCUSTOMIZE PARAMETERS
2009 Toyota Yaris Base, 4D Sedan, Automatic
Customize Parameters
2009 Toyota Yaris Base, 4D Sedan, AutomaticSECTION Customize Parameters
HINT:
The following items can be customized.
NOTE:
- After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations.
- Be sure to record the current settings before customization.
- When troubleshooting, make sure that the item in question is not set to OFF due to customization. (For example, when the problem is that the wireless function is inoperative, first check whether the wireless function has been set to OFF before troubleshooting.)
Theft Deterrent System:
CUSTOMIZE PARAMETERS - THEFT DETERRENT SYSTEM
| Display (Item) | Default | Function | Setting |
|---|---|---|---|
| Passive Mode* (Security System) (Passive Arming Mode) |
OFF | In passive arming mode, theft deterrent system switched from arming preparation state to armed state 30 seconds after both of following operations performed.
In passive arming mode, if following operations are not performed within 14 seconds of door being opened while in armed state, theft deterrent system determines that condition as theft and switches to alarm sounding state.
|
ON/OFF |
| Warning by Horn* (Warning horn) |
ON | Allows vehicle horn and security horn to be used as warning devices | ON/OFF |
| Entry Delay Time* (Entry delay time) |
14 seconds | Changes entry delay time (time before warning starts) for passive arming mode | 0/14/30 (seconds) |
*: Sedan
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.