Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSTOYOTA2009YARIS BASE, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLBRAKE CONTROLSKID CONTROL SENSORINSTALLATION
2009 Toyota Yaris Base, 4D Sedan, Automatic
Skid Control Sensor: Installation
2009 Toyota Yaris Base, 4D Sedan, AutomaticSECTION Installation
- INSTALL REAR AXLE HUB AND BEARING ASSEMBLYÂ (See INSTALLATION )
- INSPECT REAR AXLE HUB BEARINGÂ (See ON-VEHICLE INSPECTION )
- CONNECT SKID CONTROL SENSOR WIREÂ (See INSTALLATION )
- INSTALL REAR BRAKE DRUM SUB-ASSEMBLYÂ
- ADJUST REAR DRUM BRAKE SHOE CLEARANCEÂ (See INSPECTION )
- INSTALL REAR WHEELÂ
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)Â
- CONNECT CABLE TO NEGATIVE BATTERY TERMINALÂ
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)Â
- CHECK ABS SENSOR SIGNALÂ
(See CHECK FOR INTERMITTENT PROBLEMSÂ )
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.