Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009VENZA AWD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULESERVICE AND REPAIRREMOVAL
2009 Toyota Venza AWD V6-3.5L (2GR-FE)
Removal
2009 Toyota Venza AWD V6-3.5L (2GR-FE)SECTION Removal
2GR-FE ENGINE CONTROL: ECM: REMOVAL
REMOVAL
NOTICE: Perform the Vehicle Identification Number (VIN) registration when replace the ECM Repair Instruction - Initialization.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
3. REMOVE ECM
(a) Disconnect the 2 ECM connectors and remove the ECM with the brackets.
NOTICE: After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.
(1) Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.
(b) Remove the 3 nuts and separate the ECM with the brackets.
(c) Remove the 4 screws and 2 ECM brackets.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.