Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009VENZA AWD V6-3.5L (2GR-FE)REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWER AND GROUND DISTRIBUTIONPOWER DISTRIBUTION MODULESERVICE AND REPAIRPOWER MANAGEMENT CONTROL ECUINSTALLATION
2009 Toyota Venza AWD V6-3.5L (2GR-FE)
Installation
2009 Toyota Venza AWD V6-3.5L (2GR-FE)SECTION Installation
POWER DISTRIBUTION: POWER MANAGEMENT CONTROL ECU: INSTALLATION
INSTALLATION
1. INSTALL POWER MANAGEMENT CONTROL ECU
(a) Install the power management control ECU with the 2 nuts.
(b) Connect the 2 connectors.
2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation
3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation
5. INSTALL FRONT DOOR SCUFF PLATE RH Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.