Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009TUNDRA 2WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL MODULE HVACSERVICE AND REPAIRREMOVAL
2009 Toyota Tundra 2WD V8-4.7L (2UZ-FE)
Removal
2009 Toyota Tundra 2WD V8-4.7L (2UZ-FE)SECTION Removal
AIR CONDITIONING: AIR CONDITIONING AMPLIFIER: REMOVAL
REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE RH
(a) for Regular Cab:
Remove the front door scuff plate Removal.
(b) for Double Cab:
Remove the front door scuff plate Removal.
(c) for CrewMax:
Remove the front door scuff plate Removal.
2. REMOVE COWL SIDE TRIM BOARD RH
(a) for Regular Cab:
Remove the cowl side trim board Removal.
(b) for Double Cab:
Remove the cowl side trim board Removal.
(c) for CrewMax:
Remove the cowl side trim board Removal.
3. REMOVE INSTRUMENT SIDE PANEL RH
(a) for Column Shift Type:
Remove the instrument side panel Removal.
(b) for Floor Shift Type:
Remove the instrument side panel Removal.
4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
(a) for Column Shift Type:
Remove the instrument panel finish panel Removal.
(b) for Floor Shift Type:
Remove the instrument panel finish panel Removal.
5. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY
(a) Remove the screw and duct.
6. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY
(a) Disconnect the 2 connectors.
(b) Remove the 2 screws and amplifier.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.