Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
2009 Toyota Sienna XLE, FWDSECTION Inspection Procedure
- CHECK WHETHER DTC OUTPUT RECURS (IN ADDITION TO DTC P0607)
- Connect Techstream to the DLC3.
- Turn the ignition switch to the ON position.
- Turn the tester on.
- Clear the DTC.
- Turn the ignition switch off.
- Disconnect the battery negative terminal and wait for 1 minute.
- Connect the battery negative terminal.
- Turn the ignition switch to the ON position.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Code.
- Read the DTCs.
Result
RESULT REFERENCEDisplay (DTC output) Proceed to P0607 A No output DTC B
B: CHECK FOR INTERMITTENT PROBLEMS
A: REPLACE ECM
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.