Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009SIENNA XLE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEFUEL DELIVERYENGINE FUEL SYSTEMFUEL PUMPINSTALLATION
2009 Toyota Sienna XLE, FWD
Fuel Pump: Installation
2009 Toyota Sienna XLE, FWDSECTION Installation
- INSTALL FUEL TANK ASSEMBLY (See INSTALLATION )
- INSPECT FOR FUEL LEAK (See ON-VEHICLE INSPECTION )
- INSTALL FUEL TANK FILLER HOSE COVER (See INSTALLATION )
- INSTALL REAR FLOOR NO. 2 CROSSMEMBER BRACE LH (See INSTALLATION )
- INSTALL CHARCOAL CANISTER PROTECTOR
- Install the 6 bolts and the charcoal canister protector.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
- Install the 6 bolts and the charcoal canister protector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.