Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009SEQUOIA LIMITED, 5.7 Y, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 12 (STARTING SYSTEM (2UZ-FE))STARTERREASSEMBLY
2009 Toyota Sequoia Limited, 5.7 Y, RWD
Section 12 (Starting System (2UZ-FE)): Starter: Reassembly
2009 Toyota Sequoia Limited, 5.7 Y, RWDSECTION Reassembly
WARNING: This page is about a different variant/trim than selected.
- INSTALL STARTER ARMATURE ASSEMBLY
- Install the starter armature to the starter yoke.
- INSTALL STARTER BRUSH HOLDER ASSEMBLY
- Install a new O-ring to the groove of the starter yoke.
- Place the brush holder on the starter yoke.
- Using a screwdriver, hold the brush spring back.
- Connect the brush to the brush holder.
- Connect the 4 brushes.NOTE: Check that the positive (+) lead wires are not grounded.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.