Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009SEQUOIA LIMITED, 5.7 Y, RWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWARNING SYSTEMSPARK ASSIST / MONITORINGREAR VIEW MONITOR SYSTEMPROBLEM SYMPTOMS TABLE
2009 Toyota Sequoia Limited, 5.7 Y, RWD
Problem Symptoms Table
2009 Toyota Sequoia Limited, 5.7 Y, RWDSECTION Problem Symptoms Table
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Rear View Monitor System
REAR VIEW MONITOR SYSTEM
| Symptom | Suspected Area | Reference |
|---|---|---|
| When shift lever is in R, rear view monitor image is not displayed (Screen is not black). | Proceed to "Reverse Signal Circuit" | REVERSE SIGNAL CIRCUIT |
| Proceed to "Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly" | DISPLAY SIGNAL CIRCUIT BETWEEN NAVIGATION RECEIVER ASSEMBLY AND TELEVISION CAMERA ASSEMBLY | |
| Navigation receiver assembly | REMOVAL | |
| When shift lever is in R, rear view monitor image is not displayed (Screen is black). | Proceed to "Navigation Receiver Assembly Power Source Circuit" | NAVIGATION RECEIVER ASSEMBLY POWER SOURCE CIRCUIT |
| Proceed to "Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly" | DISPLAY SIGNAL CIRCUIT BETWEEN NAVIGATION RECEIVER ASSEMBLY AND TELEVISION CAMERA ASSEMBLY | |
| Television camera assembly | TELEVISION CAMERA | |
| Navigation receiver assembly | REMOVAL | |
| When shift lever is not in R, rear view monitor image is displayed. | Proceed to "Reverse Signal Circuit" | TERMINALS OF ECU |
| Proceed to "Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly" | DISPLAY SIGNAL CIRCUIT BETWEEN NAVIGATION RECEIVER ASSEMBLY AND TELEVISION CAMERA ASSEMBLY | |
| Navigation receiver assembly | REMOVAL | |
| Problem with the rear view monitor image (color, disorder of picture). | Proceed to "Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly" | DISPLAY SIGNAL CIRCUIT BETWEEN NAVIGATION RECEIVER ASSEMBLY AND TELEVISION CAMERA ASSEMBLY |
| Navigation receiver assembly | REMOVAL | |
| Television camera assembly | TELEVISION CAMERA |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.