Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINETIMING COMPONENTSTIMING COVER
2009 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Timing Cover
2009 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Timing Cover
NO. 1 TIMING BELT COVER
Install the timing belt cover with the 4 bolts.
Torque 7.5 Nm (76 kgf-cm, 66 in-lbf)
NO. 2 TIMING BELT COVER SUB-ASSEMBLY
Install the timing belt cover and fit the claws and pins into each part. Install the 2 bolts.
Torque 16 Nm (163 kgf-cm, 12 ft-lbf)
NO. 3 TIMING BELT COVER SUB-ASSEMBLY LH
Install the cover with the 4 bolts.
Torque 7.5 Nm (76 kgf-cm, 66 in-lbf)
NO. 2 TIMING CHAIN OR BELT COVER
Install the cover with the 3 bolts and nut.
Torque 7.5 Nm (76 kgf-cm, 66 in-lbf)
Install the timing belt cover with the 4 bolts.
Torque 7.5 Nm (76 kgf-cm, 66 in-lbf)
NO. 2 TIMING BELT COVER SUB-ASSEMBLY
Install the timing belt cover and fit the claws and pins into each part. Install the 2 bolts.
Torque 16 Nm (163 kgf-cm, 12 ft-lbf)
NO. 3 TIMING BELT COVER SUB-ASSEMBLY LH
Install the cover with the 4 bolts.
Torque 7.5 Nm (76 kgf-cm, 66 in-lbf)
NO. 2 TIMING CHAIN OR BELT COVER
Install the cover with the 3 bolts and nut.
Torque 7.5 Nm (76 kgf-cm, 66 in-lbf)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.