Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCOOLANT TEMPERATURE SENSOR/SWITCH (FOR COMPUTER)SERVICE AND REPAIRINSTALLATION
2009 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Installation
2009 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Installation
2UZ-FE ENGINE CONTROL: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION
INSTALLATION
1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
(a) Install a new gasket and the engine coolant temperature sensor.
Torque: 20 Nm (200 kgf-cm, 14 ft-lbf)
(b) Connect the engine coolant temperature sensor connector.
2. INSTALL AIR CLEANER HOSE ASSEMBLY Installation
3. ADD ENGINE COOLANT Service and Repair
4. INSPECT FOR ENGINE COOLANT LEAK Testing and Inspection
5. INSTALL THROTTLE BODY COVER SUB-ASSEMBLY Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.