Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONPOWER DISTRIBUTION MODULESERVICE AND REPAIRREMOVAL
2009 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Removal
2009 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Removal
POWER OUTLETS (INT): VOLTAGE INVERTER: REMOVAL
REMOVAL
1. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY Removal
2. REMOVE LUGGAGE COMPARTMENT TRIM BOX Removal
3. REMOVE ROPE HOOK ASSEMBLY Removal
4. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY Removal
5. REMOVE DECK BOARD REINFORCEMENT SUB-ASSEMBLY Removal
6. REMOVE DECK BOARD BRACKET Removal
7. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Manual Seat)
(a) Remove the rear No. 2 seat assembly LH Removal.
8. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Power Seat)
(a) Remove the rear No. 2 seat assembly LH Removal.
9. REMOVE REAR SEAT CUSHION HINGE LOWER COVER LH Removal
10. REMOVE REAR FLOOR STEP NO. 1 COVER Removal
11. REMOVE REAR FLOOR STEP NO. 2 COVER Removal
12. REMOVE REAR DOOR SCUFF PLATE LH Removal
13. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH Removal
14. REMOVE ROPE HOOK ASSEMBLY Removal
15. REMOVE REAR FLOOR MAT SUPPORT PLATE Removal
16. REMOVE QUARTER TRIM PANEL ASSEMBLY LH Removal
17. REMOVE QUARTER TRIM PANEL ASSEMBLY LH (for Power Seat) Removal
18. REMOVE VOLTAGE INVERTER
(a) Disconnect the connector.
(b) Remove the 3 bolts and remove the voltage inverter.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.