Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISLIGHTING AND HORNSTAIL LAMPSERVICE AND REPAIRREAR LIGHT ASSEMBLYREMOVAL
2009 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Removal
2009 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Removal
LIGHTING (EXT): REAR LIGHT ASSEMBLY: REMOVAL
REMOVAL
HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.
1. REMOVE BACK DOOR CENTER GARNISH Disassembly
2. REMOVE BACK DOOR SIDE GARNISH RH Disassembly
3. REMOVE BACK DOOR SIDE GARNISH LH Disassembly
4. REMOVE BACK DOOR STRAP COVER Disassembly
5. REMOVE BACK DOOR PULL STRAP Disassembly
6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY Disassembly
7. REMOVE BACK DOOR SERVICE HOLE COVER Disassembly
8. REMOVE REAR LIGHT ASSEMBLY
(a) Disconnect the connector.
(b) Remove the 2 nuts.
(c) Disengage the clip and remove the rear light.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.