Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009SEQUOIA 4WD V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISCRUISE CONTROLRELAYS AND MODULES - CRUISE CONTROLCRUISE CONTROL MODULESERVICE AND REPAIRINSTALLATION
2009 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)
Installation
2009 Toyota Sequoia 4WD V8-4.7L (2UZ-FE)SECTION Installation
CRUISE CONTROL: DISTANCE CONTROL ECU: INSTALLATION
INSTALLATION
1. INSTALL DISTANCE CONTROL ECU ASSEMBLY
(a) Install the distance control ECU with the bolt.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)
NOTE: Do not install the distance control ECU assembly if it has been damaged or received some sort of shock.
(b) Connect the connector.
2. INSTALL MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH) Installation
3. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT Installation
4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH Installation
5. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Installation
6. INSTALL INSTRUMENT SIDE PANEL LH Installation
7. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH Installation
8. INSTALL COWL SIDE TRIM BOARD LH Installation
9. INSTALL FRONT DOOR SCUFF PLATE LH Installation
10. INITIALIZE DISTANCE CONTROL ECU
(a) Initialize the distance control ECU Programming and Relearning.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.