Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009LANDCRUISER V8-5.7L (3UR-FE)REPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESSLIP INDICATOR LIGHT DOES NOT COME ON
2009 Toyota Landcruiser V8-5.7L (3UR-FE)
Slip Indicator Light Does Not Come ON
2009 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Slip Indicator Light Does Not Come ON
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: Slip Indicator Light does not Come ON
Slip Indicator Light does not Come ON
DESCRIPTION
The SLIP indicator light blinks during VSC, A-TRAC, CRAWL or hill-start assist control operation.
When the system fails, the SLIP indicator light comes on to warn the driver Diagnosis System.
WIRING DIAGRAM
INSPECTION PROCEDURE
Refer to "Slip Indicator Light Remains On" Slip Indicator Light Remains ON.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.