Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009LANDCRUISER V8-5.7L (3UR-FE)REPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSTESTING AND INSPECTIONINITIAL INSPECTION AND DIAGNOSTIC OVERVIEWDIAGNOSIS SYSTEM
2009 Toyota Landcruiser V8-5.7L (3UR-FE)
Diagnosis System
2009 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Diagnosis System
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: DIAGNOSIS SYSTEM
DIAGNOSIS SYSTEM
1. DIAGNOSIS
(a) If the skid control ECU detects a malfunction, the ABS/BRAKE warning lights and SLIP/CRAWL indicator lights and/or "Check VSC System" on the multi-information display will come on to warn the driver.
2. WARNING LIGHT AND INDICATOR LIGHT CHECK
(a) Release the parking brake lever.
NOTE: When releasing the parking brake, set chocks to hold the vehicle for safety.
HINT: When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light comes on.
(b) When the engine switch is turned on (IG), check that the ABS and BRAKE warning lights and the VSC OFF, SLIP and CRAWL indicator lights turn on and then turn off after the engine starts.
If a light remains on, proceed to troubleshooting for the light circuit below.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.