Cursor or MAP Rotates When Vehicle Stopped

2009 Toyota Landcruiser V8-5.7L (3UR-FE)SECTION Cursor or MAP Rotates When Vehicle Stopped







NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Cursor or Map Rotates when Vehicle Stopped

Cursor or Map Rotates when Vehicle Stopped

INSPECTION PROCEDURE

PROCEDURE

1. CHECK CONDITION




(a) Check with the customer if the vehicle has been turned by a turntable at parking.
OK:
Vehicle has not been turned by turntable.
HINT: If the engine switch is turned on (ACC) or on (IG) while the vehicle is being turned by a turntable, the system may store the angular velocity at this time. For this reason, the vehicle position cursor may deviate.

NG -- TURN ENGINE SWITCH ON (IG) WHEN VEHICLE IS COMPLETELY STOPPED
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.