Torque Specifications

2009 Toyota FJ Cruiser RWDSECTION Torque Specifications
TORQUE SPECIFICATIONS CHART

Part Tightened N*m kgf*cm ft.*lbf
Tie rod end lock nut 88 897 65
Front support to front shock absorber nut x Front shock absorber 25 255 18
Front shock absorber with coil spring x Frame assembly 64 653 47
Front stabilizer link assembly x Steering knuckle 70 714 52
Engine under cover sub-assembly x Frame assembly 29 296 21
Front wheel 112 1137 82
Front shock absorber x Front lower suspension arm 135 1377 100
Wire harness bracket x Frame assembly 5.8 59 51 in.*lbf
Front upper suspension arm x Steering knuckle 110 1122 81
Skid control sensor wire x Front upper suspension arm 13 127 9
Front upper suspension arm x Frame assembly 115 1173 85
Front lower ball joint attachment x Front lower suspension arm 140 1428 103
Front lower ball joint attachment x Steering knuckle 160 1631 118
Front lower suspension arm x Frame assembly 135 1377 100
Front stabilizer bracket x Frame assembly 40 408 30
Front stabilizer link assembly x Front stabilizer bar 70 714 52
Front stabilizer link assembly x Steering knuckle 70 714 52
Rear shock absorber x Rear axle housing assembly 98 1000 72
Rear brake tube flexible hose x Rear brake tube 14(15) 143(154) 10(11)
Rear wheel 112 1137 82
Rear shock absorber x Frame assembly 25 255 18
Rear upper control arm x Frame assembly 80 816 59
Rear upper control arm x Rear axle housing assembly 80 816 59
Parking brake cable x Frame assembly 13 127 9
Rear lower control arm x Frame assembly 130 1326 96
Rear lower control arm x Rear axle housing assembly 130 1326 96
Rear lateral control rod x Frame assembly 130 1326 96
Rear lateral control rod x Rear axle housing assembly 130 1326 96
Rear stabilizer bracket cover x Rear axle housing assembly 30 306 22
Rear stabilizer link assembly x Rear stabilizer bar 70 714 52
Rear stabilizer link assembly x Frame assembly 15 153 11

(): for use without SST

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.