Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009FJ CRUISER RWDREPAIR AND DIAGNOSISELECTRICALCHARGING SYSTEMSCHARGING SYSTEM (SERVICE SPECIFICATIONS)CHARGING SYSTEMTORQUE SPECIFICATIONS
2009 Toyota FJ Cruiser RWD
Torque Specifications
2009 Toyota FJ Cruiser RWDSECTION Torque Specifications
TORQUE SPECIFICATIONS CHART
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Generator assembly x V-ribbed belt tensioner and cylinder head | 43 | 438 | 32 |
| Generator assembly x Wire harness clamp bracket | 8.0 | 82 | 71 in.*lbf |
| Generator assembly x Terminal B | 10 | 100 | 7 |
| Wire harness stay x Body | 5.8 | 59 | 51 in.*lbf |
| V-bank cover x Intake air surge tank sub-assembly and Air cleaner assembly | 7.5 | 76 | 66 in.*lbf |
| Engine under cover sub-assembly No. 1 x Frame assembly | 29 | 296 | 21 |
| Retainer plate x Drive end frame assembly generator (Denso made) | 26 | 27 | 23 in.*lbf |
| Generator coil assembly x Drive frame assembly generator (Denso made) | 5.8 | 59 | 51 in.*lbf |
| Generator brush holder assembly x Generator coil assembly (Denso made) | 1.8 | 18 | 16 in.*lbf |
| Generator rear end cover x Generator coil assembly (Denso made) | 4.6 | 47 | 41 in.*lbf |
| Generator pulley x Generator rotor assembly (Denso made) | 111 | 1, 125 | 81 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.