Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009FJ CRUISER RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSWINDSHIELD/WINDOW GLASSFRONT PASSENGER SIDE POWER WINDOW SWITCHINSTALLATION
2009 Toyota FJ Cruiser RWD
Front Passenger Side Power Window Switch: Installation
2009 Toyota FJ Cruiser RWDSECTION Installation
- INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY
- Engage the 2 claws and install the power window regulator switch.
- INSTALL FRONT ARMREST BASE UPPER PANEL (See REASSEMBLY )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.