Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009FJ CRUISER RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSCRUISE CONTROL SYSTEMCRUISE CONTROL MAIN SWITCHINSPECTION
2009 Toyota FJ Cruiser RWD
Cruise Control Main Switch: Inspection
2009 Toyota FJ Cruiser RWDSECTION Inspection
- INSPECT CRUISE CONTROL MAIN SWITCH
- Measure the resistance and check the results in accordance with the value(s) in the table below.
Standard resistance
STANDARD RESISTANCETester Connection Switch Condition Specified Condition 1(ECC) - 3(CCS) Neutral 10 kΩ or higher 1(ECC) - 3(CCS) +/RES 216 to 264 Ω 1(ECC) - 3(CCS) -/SET 567 to 693 Ω 1(ECC) - 3(CCS) CANCEL 1,386 to 1,694 Ω 1(ECC) - 3(CCS) Main Switch off 10 kΩ or higher 1(ECC) - 3(CCS) Main Switch on Below 1 Ω If the result is not as specified, replace the cruise control main switch.
- Measure the resistance and check the results in accordance with the value(s) in the table below.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.