Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2009FJ CRUISER RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEPARK ASSIST / MONITORINGCLEARANCE WARNING BUZZERINSPECTION

2009 Toyota FJ Cruiser RWD

Clearance Warning Buzzer: Inspection

2009 Toyota FJ Cruiser RWDSECTION Inspection

INSPECT CLEARANCE WARNING BUZZER

Check the resistance.

Using an ohmmeter, measure the resistance between the terminals.

Standard resistance

CLEARANCE WARNING BUZZER

Tester Connection	Specified Condition
1-2	Approximately 1 kΩ

If the result is not as specified, replace the clearance warning buzzer.

Fig 1: Measuring Resistance Between Terminals Using Ohmmeter

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.