Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2009COROLLA S, 1.8 U, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (2ZR-FE) - SFI SYSTEM DIAGNOSTIC INTRODUCTION, PRECAUTIONS, PROBLEM SYMPTOMS TABLE, FAIL-SAFE CHART, DIAGNOSTIC TROUBLE CODE (DTC) CHARTSFI SYSTEMCHECK MODE PROCEDURE

2009 Toyota Corolla S, 1.8 U, Standard

Check Mode Procedure

2009 Toyota Corolla S, 1.8 U, StandardSECTION Check Mode Procedure

Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect malfunctions that cannot be detected in normal mode.

NOTE: All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from ON to ACC or OFF while in check mode. Before changing modes, always check and note any DTCs and freeze frame data.

CHECK MODE PROCEDURE
1. Check and ensure the following conditions:
  1. Battery voltage 11 V or more.
  2. Throttle valve fully closed.
  3. Transmission in P or N.
  4. A/C switch OFF.
2. Turn the ignition switch off.
3. Connect the Techstream to the DLC3.
4. Turn the ignition switch to ON.
5. Turn the Techstream on.
6. Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.
7. Switch the ECM from normal mode to check mode.
8. Make sure that the MIL flashes as shown in the illustration.
9. Start the engine.
10. Make sure that the MIL turns off.
11. Simulate that the conditions of the malfunction described by the customer.
12. Check DTCs and freeze frame data using the Techstream.
Fig 1: Malfunction Indicator Lamp Blinking Pattern
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.