Junction Block and Wire Harness Connector

2009 Toyota Corolla S, 1.8 U, StandardSECTION Junction Block and Wire Harness Connector
Code See Junction Block and Wire Harness (Connector Location)
1B : ENGINE ROOM R/B; : ENGINE ROOM J/B - ENGINE COMPARTMENT LEFT Engine Room Main Wire and Engine Room J/B (Engine Compartment Left)
2B : INSTRUMENT PANEL J/B - COWL SIDE LEFT Engine Room Main Wire and Instrument Panel J/B (Cowl Side Left)
2C : INSTRUMENT PANEL J/B - COWL SIDE LEFT Instrument Panel Wire and Instrument Panel J/B (Cowl Side Left)
2H
2M : INSTRUMENT PANEL J/B - COWL SIDE LEFT
3B : J/B NO. 3 - COWL SIDE RIGHT Instrument Panel Wire and J/B No. 3 (Cowl Side Right)
4A : J/B NO. 4 - INSTRUMENT PANEL BRACE RH Instrument Panel Wire and J/B No. 4 (Instrument Panel Brace RH)
4B
4C
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.