SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2009COROLLA S, 1.8 U, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLBRAKE CONTROL/DYNAMIC CONTROL SYSTEMANTI-LOCK BRAKE SYSTEMDTC U0073/94 CONTROL MODULE COMMUNICATION BUS OFFDESCRIPTION
2009 Toyota Corolla S, 1.8 U, Standard

DTC U0073/94 Control Module Communication Bus OFF: Description

2009 Toyota Corolla S, 1.8 U, StandardSECTION Description

The skid control ECU receives signals sent from the ECM via the CAN communication system. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.

DTC DETECTION CONDITION CHART

DTC Code DTC Detection Condition Trouble Area
U0073/94 Either of the following is detected:
  1. When the IG1 terminal voltage is between 10 and 17.4 V, after the output of data from the skid control ECU is completed, the sending continues for 5 seconds or more.
  2. When the IG1 terminal voltage is between 10 and 17.4 V, the condition that bus OFF state occurs once or more within 0.1 seconds occurs 10 times in succession. (Sent signals cannot be received.)
 CAN communication system
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.