Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electric Steering Lock: Initialization
HINT:
In vehicles equipped with the smart key system function, the starting function may not operate after recharging or while jump-starting a discharged battery. This condition is most common if the battery voltage drops below 9 V. The following procedure has been developed to address this condition.
- INITIALIZATION PROCEDURE
- Confirm that the short pin is installed.
HINT:
If the short pin is not installed, install it at this time.
- Move the shift lever to the P position.
- Turn the power switch off.
- Open the driver's door.
HINT:
Opening the driver's door will start an initialization process between the steering lock ECU and the engine room J/B.
- Depress the brake pedal.
- Press the "START STOP" switch.
- Confirm that the short pin is installed.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.