Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2009CAMRY HYBRIDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEM (HYBRID)CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLYINSTALLATION

2009 Toyota Camry Hybrid

Camshaft Timing Oil Control Valve Assembly: Installation

2009 Toyota Camry HybridSECTION Installation

INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
1. Apply a light coat of engine oil to an O-ring of the camshaft timing oil control valve assembly sensor.
  
  Fig 1: Locating Camshaft Timing Oil Control Valve O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the camshaft timing oil control valve assembly with the bolt.
  Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)
3. Connect the camshaft timing oil control valve assembly connector.
Fig 2: Locating Camshaft Timing Oil Control Valve Assembly Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
1. Install the brake master cylinder reservoir sub-assembly with the 2 bolts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 3: Locating Brake Master Cylinder Reservoir Sub-Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (See INSTALLATION )

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.