Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA20094RUNNER LIMITED, 4.0 U, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEM (1GR-FE)SFI SYSTEMDTC P0607: CONTROL MODULE PERFORMANCEINSPECTION PROCEDURE
2009 Toyota 4Runner Limited, 4.0 U, RWD
Inspection Procedure
2009 Toyota 4Runner Limited, 4.0 U, RWDSECTION Inspection Procedure
- CHECK DTC
- Clear DTC.
- Turn the ignition switch off.
- Disconnect the battery negative terminal and wait for 1 minute.
- Connect the battery negative terminal.
- Turn the ignition switch on.
- Check DTC.
OK:
P0607 is not present.
NG: REPLACE ECM
OK: CHECK FOR INTERMITTENT PROBLEMS
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.