Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA20094RUNNER LIMITED, 4.0 U, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEM (1GR-FE)ACCELERATOR PEDAL RODINSTALLATION

2009 Toyota 4Runner Limited, 4.0 U, RWD

Accelerator Pedal Rod: Installation

2009 Toyota 4Runner Limited, 4.0 U, RWDSECTION Installation

INSTALL ACCELERATOR PEDAL ROD ASSEMBLY
NOTE:
- Avoid physical shock to the accelerator pedal assembly.
- Do not disassemble the accelerator pedal assembly.
1. Install the accelerator pedal assembly with the 2 nuts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 1: Identifying Accelerator Pedal Assembly Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the accelerator pedal connector.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.