Check For Intermittent Problems

HINT:

A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected by using the ECU data list function of a Techstream.

1. Turn the ignition switch off and connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Follow the prompts on the Techstream to display the Data List and select areas where a momentary interruption should be monitored.

   HINT:

   • A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
   • If the status remains on the ERROR display, check for continuity between the ECU and the sensors, or between ECUs.
   • The ERROR display on the Techstream remains on for 1 second after the harness signal changes from a momentary interruption (open circuit) to normal condition.
     Fig 1: Harness Signal And Tester Display Blinking Pattern

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
     DATA LIST REFERENCE
     
     

     Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
     FR Speed Open	FR speed sensor open detection / ERROR or NORMAL	ERROR: Momentary interruption NORMAL: Normal	-
     FL Speed Open	FL speed sensor open detection / ERROR or NORMAL	ERROR: Momentary interruption NORMAL: Normal	-
     RR Speed Open	RR speed sensor open detection / ERROR or NORMAL	ERROR: Momentary interruption NORMAL: Normal	-
     RL Speed Open	RL speed sensor open detection / ERROR or NORMAL	ERROR: Momentary interruption NORMAL: Normal	-

4. While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

   OK: 

   Display does not change. 

   HINT:

   The connector and/or wire harness have a momentary interruption (open circuit) if the display changes. Repair or replace the connector and wire harness if either of them is faulty.

   Fig 2: Jiggling Connector Or Wire Harness Between ECU And Sensors

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002