Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008TACOMA BASE, 2D PICKUP, RWD, STANDARDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTEXTERIOR LIGHTSLIGHTING SYSTEMSTOP LIGHT SWITCHINSPECTION
2008 Toyota Tacoma Base, 2D Pickup, RWD, Standard
Stop Light Switch: Inspection
2008 Toyota Tacoma Base, 2D Pickup, RWD, StandardSECTION Inspection
- INSPECT STOP LIGHT SWITCH
- Check the resistance.
- Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in STOP LIGHT SWITCH .
Standard
STOP LIGHT SWITCHTester Connection Condition Specified Condition 1-2 Switch pin free Below 1 3-4 Switch pin free 10 k or higher 1-2 Switch pin pushed in 10 k or higher 3-4 Switch pin pushed in Below 1 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
If the result is not as specified, replace the stop light switch assembly.
- Measure the resistance using an ohmmeter, and check the results in accordance with the value(s) in STOP LIGHT SWITCH .
- Check the resistance.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.