Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008TACOMA BASE, 2D PICKUP, RWD, STANDARDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTEXTERIOR LIGHTSLIGHTING SYSTEMLICENSE PLATE LIGHT ASSEMBLYINSTALLATION
2008 Toyota Tacoma Base, 2D Pickup, RWD, Standard
License Plate Light Assembly: Installation
2008 Toyota Tacoma Base, 2D Pickup, RWD, StandardSECTION Installation
- REMOVE LICENSE PLATE LIGHT ASSEMBLY
- Install the license plate light bulb into the light socket.
- To install the license plate light bulb socket and bulb, turn them in the direction indicated by the arrow in Fig 1.
- Install the license plate light assembly with the screw.
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.