SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008TACOMA BASE, 2D PICKUP, RWD, STANDARDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTEXTERIOR LIGHTSLIGHTING SYSTEMFOG LIGHT ASSEMBLYINSTALLATION
2008 Toyota Tacoma Base, 2D Pickup, RWD, Standard

Fog Light Assembly: Installation

2008 Toyota Tacoma Base, 2D Pickup, RWD, StandardSECTION Installation
  1. INSTALL FOG LIGHT ASSEMBLY 
    1. Install the fog light bulb into the light socket.
    2. To install the fog light bulb socket and bulb, turn them in the direction indicated by the arrow in Fig 1.
      Fig 1: Turning Fog Light Bulb Socket And Bulb
      G04412468Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Engage the 2 claws and install the fog light assembly LH.
    4. Connect the connector.
  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

    Fig 2: Connecting Cable
    G04412469Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. VEHICLE PREPARATION FOR FOG LIGHT AIM ADJUSTMENT (See  ADJUSTMENT   ) 
  4. PREPARATION FOR FOG LIGHT AIMING (See  ADJUSTMENT   ) 
  5. FOG LIGHT AIMING INSPECTION (See  ADJUSTMENT   ) 
  6. FOG LIGHT AIMING ADJUSTMENT (See  ADJUSTMENT   ) 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.