Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2008RAV4 LIMITED, 2.4 D, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (2AZ-FE)ECMINSTALLATION

2008 Toyota RAV4 Limited, 2.4 D, FWD

Engine Control System (2AZ-FE): ECM: Installation

2008 Toyota RAV4 Limited, 2.4 D, FWDSECTION Installation

INSTALL ECM
1. Install the 2 brackets to the ECM with the 4 screws.
  Torque: 3.0 N*m (30 kgf*cm, 27 in.*lbf)
  
  Fig 1: Identifying ECM Brackets Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the 2 ECM connectors.
  NOTE: When connecting the connector, make sure that dirt, water and other foreign matter does not become stuck between the connector and other part.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.