Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008RAV4 LIMITED, 2.4 D, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM (2AZ-FE) (SERVICE SPECIFICATIONS)2AZ-FE ENGINE CONTROL SYSTEMTORQUE SPECIFICATIONS
2008 Toyota RAV4 Limited, 2.4 D, FWD
Torque Specifications
2008 Toyota RAV4 Limited, 2.4 D, FWDSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Camshaft timing oil control valve x Timing chain cover | 9.0 | 92 | 80 in.*lbf |
| Engine coolant temperature sensor x Cylinder head | 19.6 | 200 | 14 |
| Camshaft position sensor x Cylinder head | 9.0 | 92 | 80 in.*lbf |
| Crankshaft position sensor x Timing chain cover | 9.0 | 92 | 80 in.*lbf |
| Throttle body x Intake manifold | 30 | 305 | 22 |
| No. 1 engine cover x Cylinder head cover | 7.0 | 71 | 62 in.*lbf |
| Knock sensor x Cylinder block | 20 | 205 | 15 |
| Intake manifold x Cylinder head | 30 | 305 | 22 |
| No. 2 ECM bracket x ECM | 3.0 | 30 | 27 in.*lbf |
| No. 1 ECM bracket x ECM | 3.0 | 30 | 27 in.*lbf |
| ECM with bracket x Body | 6.5 | 66 | 57 in.*lbf |
| Air cleaner case x Body | 5.0 | 51 | 44 in.*lbf |
| Accelerator pedal x Body | 5.4 | 55 | 48 in.*lbf |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.