Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2008RAV4 LIMITED, 2.4 D, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEM (2AZ-FE)CAMSHAFT POSITION SENSORINSPECTION

2008 Toyota RAV4 Limited, 2.4 D, FWD

Camshaft Position Sensor: Inspection

2008 Toyota RAV4 Limited, 2.4 D, FWDSECTION Inspection

INSPECT CAMSHAFT POSITION SENSOR

Measure the resistance of the sensor.

Standard resistance

RESISTANCE SPECIFICATION

Tester Connection	Specified Condition
1 (G+) - 2 (G-)	835 to 1,400 Ω at Cold
1 (G+) - 2 (G-)	1,060 to 1,645 Ω at Hot

Fig 1: Identifying Resistance Between Camshaft Position Sensor Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.