SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2008RAV4 LIMITED, 2.4 D, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSWINDSHIELD/WINDOW GLASSPOWER WINDOW CONTROL SYSTEMDTC B2313 GLASS POSITION INITIALIZATION INCOMPLETEINSPECTION PROCEDURE
2008 Toyota RAV4 Limited, 2.4 D, FWD

Inspection Procedure

2008 Toyota RAV4 Limited, 2.4 D, FWDSECTION Inspection Procedure
NOTE: When using Techstream to troubleshoot the LIN communication line: Connect Techstream to the vehicle, and turn the courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.
  1. CHECK DTC OUTPUT 
    1. Turn the ignition switch ON and initialize the power window regulator motor (on the driver side) (see INITIALIZATION  ).
    2. Turn the ignition switch OFF.
    3. Wait for at least 10 seconds, and then turn the ignition switch ON.
    4. Check whether the DTC output recurs.

      Result 

      DTC OUTPUT REFERENCE

      Display (DTC Output) Proceed to
      B2313 A
      No output B

    B: END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED) 

    A: REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side) 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.